Water in engine
Ok, long story short, I have a wr250x that took a dive in some deep water. It sucked up a pretty good amount of water and died. after pulling the spark plug and getting as much water out as possible, I tried starting it again. It would turn over and sound

Moroso 63595 Water Pump
Does anyone know how far the Moroso 63595 pump sticks out from the timing cover?

Motor Plate with alternator
Does anybody have any pictures of a front motor plate while using an alternataor. I need some ideas on how to mount my alternator. Thanks Tore

motorhome water stains
does any one know of a good way to remove water stains on the front h/lining these have been on a long while [10 years according to previous owner] or can you still get head lining material as i have had a god look and i think with a little care it

mechanical water pump v/s 850hp
Is anybody running a mechanical water pump with 800 plus hp, 14:1cr drag only ? What about with the electric drive motor? Thanks

Water Pump Spacer
I had these .125" thick aluminum water pump spacers laser cut for use on BBF engines that use an aluminum motor plate and OEM style water pump. They provide the required space for the water pump impeller and the flat motor plate. Eliminates the

Who runs a Moroso/Mr Gasket water pump drive kit?
I have been thinking about trying this deal. Just don't know how good they work at keeping the water moving. This will be on my 99% track only truck with a dove headed 472 on race gas. Any advice good or bad is welcome. mike

Nuevo II EK Water Leaks
Has anyone else had problems with the off/white light grey 12mm water pipe connectors I have had to replace all the fittings with new black ones on all the joints which are accessible because of water leaking when the system pressures up,now I have water

Write-Up: Water Pump Change for '89 LeSabre w/ 3800
PS - This is very similar on a supercharged engine. You must remove entire front motor mount and idler pulley in front of waterpump to get waterpump out. Make sure to push power sterring pump to the side to access bolt for motor mount bracket. I will have

Water Methanol Injection mods for the summer
Ive have a few plans to modify my water injection system ready for the summer to help cope with the heat soak my little GT cooler can tend to duffer from following some interesting reading on a Vauxhall forum I would love to fit the large FMIC but to

Advise on oil/water pump rebuild
Got a 1985 rt just before Christmas this year and have sent time getting her ready for a trip next month to the south of France (about 2400m round trip). Done all the usual things and have her running pretty sweetly now. Only thing left is the possible

Huge oil leak at front of LT1 motor after water pump replacement
Hello Longroof Members, I hope you guys are doing well. I just got finished replacing the water pump on my 95 Buick Roadmaster Estate Wagon. It has the LT1 engine with the Optispark distributor beneath the water pump. The water pump was leaking

home made front plate
would it be ok to make a front plate into 2 pieces and mount them to the heads instead of mounting them to the front cover..but if i mount it to the front cover do i still have to use the water pump backing plate

504" BBF Motor For Sale with exhaust system
1971 Block 504 cubic inch .040 bore 4.400 Diamond racing dished pistons 9:8:1 compression total seal rings BME aluminum rods 4.145 stroke Stock crank (off-set grinded) Crank was checked out and seemed to be a early year crank ARP bolts

Oil Leak from front of motor
I have this infuriating little oil leak at the front of the motor that I cannot find. Thought it was the cam timing chain cover and resealed it 3 times, so that's not it, then thought Hall Sensor cover but that's not it, so now I'm thinking water/oil pum