chassis table??

Dave Maxwell at 23h46
02
Apr
2010
chassis table??

getting ready to build a chassis table.
wondering if 3x3 1/8th inch is strong enough?
will have 6 legs and be a rectangle.
should i step up to 4x4 or 3x3 with 3/16th wall.
will just be a perimeter with adjustable cross memebrs for suspension placement.

Thanks for any info.
building a overhead crane for placement and removal of vehicle
About
This topic belongs to the forum
  • Numbers of topics : 13943
  • Numbers of messages : 164954
  • Numbers of users : 2851
  • Numbers of points : 11467
Similar topics
Going to post pictures and updates of my chassis rebuild. I used to romp a stock pressed steal noma chassis, until the crappy thing split on me. It's still useable, but with an opposed twin, locked diff and a much more extreme place to ride it, Im going
I was suggested to switch to a CS chassis... Any suggestions on a good shaft driven one?
Just want to share My M03 converted for Off-Road/ Rally
Let’s get discussions going here in the technical thread Based on all the reviews and feedback given to the different available Drift Chassis Kits in the market such as the Tamiya VDF (biased cos I have one), OTA street Jam & R2, Enroute JXR, Yokom
1996 UnderCover Dragster hardtail chassis, Advanced ET cert until 8/12. Set-up for BBF and shorty "glide , comes w/motorplates and coupler. Strange rear w/4.30 gear, Strange brakes and rotors. Complete MSD ignition, 7AL2, , 3 step Griffen
Forums from same category
See also
more_less
Informations

17 Replies For the topic :
"chassis table??"

This topic has been viewed 4013 times.

Last message :
02/04/2010 at 23h46 by "Dave Maxwell"