Question about the cubic inch chart

cobrakid8 at 07h26
24
Jan
2010
Question about the cubic inch chart

Hey guys just had a quick question on the cubic inch chart for a 460. The motor is 4.440 bore, stroke is 4.150, and it has a 6.8 rod length. So my question is,does the rod length actually make the cubic inches any more because most of the charts I have seen do not even take it into account. The bore and stroke equal around 514 but I am not sure if the rod length would change it at all and if it does anyone know what CID this motor would be at?

Read more
Reply
About
This topic belongs to the forum
  • Numbers of topics : 13943
  • Numbers of messages : 164954
  • Numbers of users : 2851
  • Numbers of points : 11467
Similar topics
806 cubic inches ........
wow an 6.00 arm with an A460 block http://www.rpmmachine.com/ford-460-806-stroker.shtml
Thoughts on this build - A head 533
I am, for the most part, copying the Trick Flow/Summit build from a couple years ago. For a reminder, here is a c/p from trick flows site. http://www.trickflow.com/articles/stroker_3/ King Daddy 520 Strokers Wild Part 3 Building King Daddy 520
Carb Size for 504 cubic inch?
I currently run a 1000cfm 4150 carb and few friends telling me i need a 1050 Dominator for my motor. What do you guys recommend? Thanks
700 cubic inch
what heads would be the best option? 2carbs with a 500 shot to start.. hemi or thors or the new idt?. like to see around 1400-1450 on motor. is this even possible.thanks
cubic inch vs. "the budget"
so im starting to gather my parts for the next build , and as you guys know im more of a bling kinda of guy , i mean who else buys a danny bee to go along with his edelbrock heads but i would really like to do a 4.60 bore and a 4.60 stroke ( 612 ),
Forums from same category
See also
more_less
Informations

7 Replies For the topic :
"Question about the cubic inch chart"

This topic has been viewed 979 times.

Last message :
24/01/2010 at 07h26 by "cobrakid8"