Diamond piston clearance

Carl at 20h38
16
Sep
2009
Diamond piston clearance

Early inventory reduction sale:
-These prices are never coming around again. Don't miss out!

1 set: -30cc dish, +.030, Kaase reliefs, 1.35CH, 529 grams, SOLD

1 set: -28cc dish, +.040, OEM reliefs, 1.35CH, 546 grams, $699.00

2 sets: -7cc flat tops, +.040 and +.060, Dual OEM/Kaase releifs, 1.765CH, SOLD OUT

1 set: +10cc dom
About
This topic belongs to the forum
  • Numbers of topics : 13943
  • Numbers of messages : 164954
  • Numbers of users : 2851
  • Numbers of points : 11467
Similar topics
Guy's at what point is to much and would need pistons replacement? This is a all out N/A drag motor in a Dragster. Ace
I had a few seizures on my return some of these are we believe down to carburation, but we are now thinking it may also be down to insuficient pistion clearance or the wrong ovaility. so there seem to be many different types of barrels- any comments
I am trying to sell the other block I have, and a question was brought up about piston clearance. Block has been bored and honed .030 to give a bore of 4.390. I am unsure for what type of rings it was honed for. If it needs to be re-honed, how would
what is the minimum radial clearance for piston to valve clearance? In other words how much clearence do I need between the out side diameter of the valve and the outer wall of the valve notch? This is a TFS A460 headed motor. here are some pics of clay.
I am looking at a 1974 Glastron Carlson with a 460/Berkley jet drive. The engine is toast - current owner says previous owner ran it without the engine cover on and it gulped some water and seized the engine and bent the rods. Not sure about this story bu
Forums from same category
See also
more_less
Informations

4 Replies For the topic :
"Diamond piston clearance"

This topic has been viewed 1009 times.

Last message :
16/09/2009 at 20h38 by "Carl"