SHAFT MOUNTED ROCKER ARMS

c.evans at 22h08
26
Jun
2011
SHAFT MOUNTED ROCKER ARMS

Shaft mounted rockers.


The picture above is of W.W. rockers on a Pro-Filer 205 head. This is showing the correct geometry pattern with the valve closed and the roller to the inside a little bit.

The above picture shows the bottom side up of a Pro

Read more
Reply
About
This topic belongs to the forum
  • Numbers of topics : 13943
  • Numbers of messages : 164954
  • Numbers of users : 2851
  • Numbers of points : 11467
Similar topics
PRW rocker arms
Does anybody know whether the prw #0246003 rocker arm will clear a460 head 1.640 springs? Thanks
JT557 HERE NEED 7.3 ROCKER ARMS GOT ANY
contact JT557
WTB: set of original rail-type rocker arms
I need a set of usable original rail-type rocker arms, fulcrums & pushrods for the '70 / '72 429/460 engines. These were the posi-stop type with a 3/8 SAE nut. Thanks, Rick,....located in the Knoxville, TN area.
Polly locks contacting rocker arms
It seems like the polly lock is going to far down on the stud & the nut part of the polly lock is barely hitting the inside of the rocker. The heads are aluminum a429, roller rockers, roller solid cam, the valve lash calls for .014 cold. Checked the
Erson 1.73 aluminum rocker arms with locks - $40
Set of 16, but one has a bad roller axle. Almost like the hardness wasn't up to snuff, the roller wheel just sawed the pin diameter down. Maybe you've got a set of Ersons and want some back-ups? Or, maybe you want to fix the pin on this one? Up to you
Forums from same category
See also
more_less
Informations

60 Replies For the topic :
"SHAFT MOUNTED ROCKER ARMS"

This topic has been viewed 5092 times.

Last message :
26/06/2011 at 22h08 by "c.evans"