DIY sliding drawer system for Toyota Landcruiser 100 series

4rd at 03h39
21
Jun
2012
DIY sliding drawer system for Toyota Landcruiser 100 series

Hi,

Thought I would share my recent project as we get ready for a trip to central Australia (hopefully we will get a chance to visit Arltunga....). I did shop around first and the asking price for a new set-up was anything up to $2700 and that did not include installation!!

So here's my home made solution in build stages:

25mm square tubing for extra strength, note the use of tie down bolts to existing tie-down rings (no holes/screws [......]
About
This topic belongs to the forum
  • Numbers of topics : 7668
  • Numbers of messages : 67322
  • Numbers of users : 5881
  • Numbers of points : 6159
Similar topics
I'm trying to clean up the model bench a little with the models that have taken up residence. This cruiser has been on a while too. I sctratch built the bullbar and towbar and modified the back doors of the wagon. One day down the track I'll put some
Each year I take part in a Cannonball Run community build on another forum (was Scale Auto until we moved it to Model Car Mag when SA stopped allowing polls on their forum).  You build the car you would use to drive from sea to shining sea.  The only rule
I bought a complete system from: http://www.abspowerbrake.com/ehpm.html I am asking $900 shipped to the lower 48 states. Thanks, Mike
Hey everybody! I've meant for sometime to become involved with the NCFJ's as I've run across several of you at events and just out wheeling. We are a new sponsor of the 2nd Annual Truck Show and really stoked to support the Wounded Warrior project! We als
I was sittin there thinkin the other day, that no one has done a Tojo ute in 1:24 scale. so I thought I'd give it a bash! I have never made any car completely out of plastic card. so this could be interesting. a 75 series ute was parked out front of
Forums from same category