Changing a Ford 9 Inch third member?

RustyKarr at 04h47
20
May
2008
Changing a Ford 9 Inch third member?

I'm wanting to change my gear ratio in the back of my ford and wanted to know if anyone knew of any websites with a "How to article"?

Thanks,
Chad

Read more
Reply
About
This topic belongs to the forum
  • Numbers of topics : 4989
  • Numbers of messages : 50457
  • Numbers of users : 1638
  • Numbers of points : 3468
Similar topics
Need help.. 9" Ford 3rd member OEM dimensions??
I have measured several, but they vary all over the place. I found an old link to the original Ford drawings, but the link was dead. Anyway, if anyone knows where I can get this info, I would greatly appreciate it. Thanks, David
stock ford 9 inch locker spine count.
does anyone know what the stock spline count was for factory 9in locker rearends? i heard there all 28 spline.
Ford 9" 33 spline axle gears or locker unit?
I have, for my 4 speed 69 Sportsroof Mustang, a nodular 9" inch housing with 2.891 bearings, a 33 spline spool, and matching 33 spline Moser axles. I was originally going to build a mild (11 second) single purpose drag car and use those parts. I've
WTB: Fox body K member
I'm looking for an aftermarket K member and lower control arms for a '79-'93 Mustang. QA1, Granatelli, etc. Looking for the street version.
Ford truck 9 inch, locker, 3.73, moser
Trying to help a friend sell a rear end out of a 68/69 ford truck. Its a 9 inch with detroit locker, richmond 3.73, moser axles, and stock case. Sold truck without rear, no longer needs rear end. $900.00 obo
Forums from same category
See also
more_less
Informations

4 Replies For the topic :
"Changing a Ford 9 Inch third member?"

This topic has been viewed 1689 times.

Last message :
20/05/2008 at 04h47 by "RustyKarr"