Timing Belt Warning Light, how to reset?

Dwayne at 09h37
02
Dec
2008
Timing Belt Warning Light, how to reset?

Hi, does anyone know how to reset the timing belt (T-Belt) warning light on the dash of an analog odometer (once its hit 100k)?
This is for a KZH106 1995 Hiace model with no tacho meter, has the door open indicator in its place.
About
This topic belongs to the forum
  • Numbers of topics : 2192
  • Numbers of messages : 12235
  • Numbers of users : 1519
  • Numbers of points : 789
Similar topics
The timing belt change light comes on every time you roll 100,000 kilometres regardless of when the belt is actually changed. To reset it, remove the lower right section of the dashboard by removing the 2 screws that hold on the fuel filler cover
1KZ-TE engine at what km's does the timing belt light come on the dash. I thought it was at 100.000 km's. Mine has gone to 107000 km's now and no warning light.
Hi, my tbelt light has come on. Found out it is because it has just done the magic 100,000km I also lost a wiper blade on the motorway, (was on my way to catch ferry, so nice man in Halfords taped a wiper blade on for me, as he said it had sheared off,
My v-belt light came on at 9,000 miles and I paid the dealer for a new belt even though it seemed too soon. But only 2,000 miles later the light came on again. I was almost afraid to ride the bike thinking I had to get it right back to the dealer, when I
1.With ignition Key in the OFF position - Belt cover side of quad. 2.Unplug belt sensor (2 wire)(flat connector) and the 4 wire harness (square connector) next to it (black connector) 3.Jumper the orange/green wire to the gray (possibly gray/green)
Forums from same category
See also
more_less
Informations

11 Replies For the topic :
"Timing Belt Warning Light, how to reset?"

This topic has been viewed 10000 times.

Last message :
02/12/2008 at 09h37 by "Dwayne"